Missile Weapon Standards

From SCA Lochac
Revision as of 09:52, 24 April 2021 by Angele (talk | contribs)
Jump to navigation Jump to search

General

  1. You bear final responsibility for the condition and safety of your own equipment.
  2. Weapons must be licensed if required by mundane law.
  3. No metal or unapproved rigid plastic may be used on any striking surface of a weapon.
  4. No missile weapons intended to simulate firearms, slings, slingstaffs, nor atlatls can be used in the field of armoured combat.
  5. No weapon may use the combustion of flammable materials as a means of propulsion.
  6. No weapon may use compressed gas as a means of propulsion.
  7. All projectiles must have the owner's name, and group clearly and legibly printed on it in English characters for identification.
  8. Missiles must not contain any material which could enter a combatant's eyes if the missile breaks open e.g. beans, sand, etc.

Bows

  1. You may use any recurve or longbow that is in a safe and usable condition, so long as the bow is greater than 20 pounds of draw weight at 28 inches of draw, and does not exceed 30 pounds draw weight at 28 inches of draw, however manufacturing standards allow for up to 31 pound bows to be sold as 30 pound, so are allowed. Bows which cannot be drawn to 28 inches may not be used.
  2. The draw weight of the bow is to be determined at 667mm (26 1/4 inches) draw length, as measured from the nocking point to the pivot point of the bow (the part of the bow in contact with the webbing of your thumb)
  3. Combat archers in Australia may not use crossbows, due to SCA Ltd's insurance policy prohibiting the use of crossbows with moving targets.
  4. Combat archers in New Zealand may use a crossbow provided that it is in a safe and usable condition, so long at the bow is greater than 400 inch-pounds, and does not exceed 600 inch-pounds in power.
  5. The power of a crossbow is determined by multiplying the length of the power stroke in inches by the draw weight in pounds at the locked position on the string. The draw weight is to be measured at the nut, ie. the string position when the crossbow is nocked. The power stroke is the distance from the string's rest position to the locked position.
  6. Compound bows and compound crossbows are not permitted.
  7. No non-Society period sights, spring/flipper rests, plunger buttons, stabilisers, clickers or modern string release aids may be used.
  8. Bow/crossbows must be powered solely by the flex of the limbs.
  9. Modern pistol grips are not allowed on crossbows.
  10. Bows shall be inspected before use by a marshal who is knowledgeable regarding archery equipment and safety. All equipment must have its poundage and draw physically measured with a ruler or other metered device and poundage scale.
  11. The use of bows and crossbows that have a period appearance is strongly encouraged.

Arrows and Bolts

Figure 10. Blunt attachment
(a) Blunt without tape
(b) Blunt with tape
(a) Blunt without tape (b) Blunt with tape
  1. New designs for materials for blunts, shafts, etc. must first be tested at kingdom level for safety and durability in consultation with the Kingdom Armoured Combat Marshal, the Kingdom Archery Marshal and the Earl Marshal and the Society Marshal.
  2. Shafts must have a diameter of 8 mm (5/16 inch)
  3. Shafts must be made from one of the following woods:
    1. Port Orford Cedar (Chamaecyparis lawsoniana or Lawson Cypress)
    2. Silver Ash (Flindersia bourjotiana)
    3. Tasmanian Oak (Eucalyptus regnans or mountain ash, Eucalyptus obliqua or stringybark or messmate, Eucalyptus delegatensis or alpine ash or woollybutt, or Victorian Ash)
    4. Western Red Cedar (Thuja plicata or giant cedar or shinglewood)
  4. The maximum length for an arrow is 711mm (28 inches), measured from the bottom of the nock slot to where the blunt joins the shaft.
  5. Arrows must be tipped with a mark II or III Riverhaven black rubber blunt affixed to the shaft.
  6. The shaft of the arrow shall be spirally or longitudinally wrapped with fibreglass filament tape, totally covering the surface from the front of the fletching to the tip of the shaft. The taping must be in good condition without any sign of the fibres lifting from the shaft.
  7. Metal points, if any, must be removed prior to mounting the blunts. The front end of the shaft must be flat, not pointed.
  8. Blunts must be secured using a strip of good quality 13mm-wide electrical or fibre tape wound down around the sides of the blunt for at least 13mm, and then up onto the shaft of the arrow for 25mm as per figure 10.1. Blunts must be firmly secured to the shaft so that they cannot come off on impact or if the shaft is broken. To allow inspection of possible punch-through the face of the blunt must not be covered.

Other missile weapons

  1. Hand-held mechanically launched missiles:
    1. Hand-held mechanically launched missiles must weigh no more than 500 grams.
    2. Tennis ball missiles shall not exceed 85 grams in weight. The balls may be perforated with a hole of no more than 6mm in diameter. To prevent them from collapsing when stepped on, tennis balls may not be slotted.
    3. The maximum range for 85 gram (3 ounce) tennis ball missiles launched from a hand-held weapon is 87 metres (90 yards), and for 56 gram (2 ounce) tennis ball missiles 91.44 metres (100 yards).

Siege Munitions

  1. Siege-class munitions are denoted by yellow tape and include ballista bolts and rocks (450g foam or 4-tennis ball clusters).
  2. Small-arms munitions include single tennis balls and tube-shafted combat archery arrows and bolts.